Dimarzio Will Power Middle Manuel d'utilisateur télécharger pdf

DiMarzio Model P® Bass Pickup

Important: Read all of the following instructions before proceeding. If any questions or

problems arise, you may refer them directly to us.

The Model P® is a direct replacement pickup, for installation in all Precision

basses except those instruments of very early release which do not have two-

section pickups. No modification to the standard Precision bass is necessary. If

you choose, an optional miniature switch can be installed to provide Dual-Sound

capability. Instructions for wiring this switch are included in Part II of this sheet.

Part 1

The first step is to remove the original pickup. This can be

accomplished by the following: unscrew all screws fastening the

pickguard to the bass, and lift the pickguard carefully from the

instrument. You will have to loosen the strings to accomplish this.

Now remove the four screws holding the original pickup in place. You

can now disconnect the pickup by unsoldering the two wires that

connect it to the bass. Unsolder the two wires furthest from the

pickup; one wire should be disconnected where it is soldered to the

volume pot, and the other where it connects to the base plate

underneath the pickup. The pickup can now be removed from the

bass. Both halves of the original pickup can be left connected

together. Now install the Model P® pickup: draw all four wires from

the Model P® through to the control department, and then screw the

two halves of the pickup into the bass. It does not matter which side

the two halves sit in.

Solder the red wire to the same leg of the volume pot the original

pickup was connected to. Solder the green wire to ground, preferably

the back of the pot. Solder the white and black wire together. You

should then put a piece of tape on this solder connection, to make

sure it does not make contact with any other part of the circuit. You

can now replace the pickguard, retune the strings and adjust the

heights of the Model P® sections to suit taste. Fine adjustments can

be made with the pole pieces.

Part II Dual Sound Installation

e 1 of 3D i M a r z i o . c o m

5/6/2004htt

://www.dimarzio.com/install/model

.html

1 2 3

Résumé du contenu

Page 1

DiMarzio Model P® Bass Pickup Important: Read all of the following instructions before proceeding. If any questions or problems arise, you may ref

Page 2

***** DiMARZIO, INC. 1388 Richmond Terrace Post Office Box 100387 If you want Dual Sound capabilities, you will need a double pole, double-throw m

Page 3 - Fax: 718-720-5296

Staten Island, NY 10310 Toll Free Order Desk (outside NYC): 800-221-6468 Customer Service (and NYC orders): 718-981-9286 Technical Assistance (12:0

Modèles reliés Model P

Commentaires sur ces manuels

Pas de commentaire

Dimarzio Will Power Middle Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Instruments de musique Dimarzio Will Power Middle. DiMarzio Will Power Middle User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés Model P

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de musique Dimarzio Will Power Middle